What Is Ornamental Concrete?

What Is Ornamental Concrete?

What is decorative concrete? Ornamental concrete is basically concrete that has no real construction value. Its primarily for the purpose of improving property value and eye appeal. Ornamental concrete additionally makes it more simpler to maintain. Concrete could be very porous and crumbly, so these two things make it very unattractive.

Totally different kinds of ornamental concretes are skim coats, overlays, stamped concrete, acid staining, alkaline staining, polishing, stain and polishing, and apoxie coatings. Skim coatings are often 1/16 of an inch. They're made of Portland cement and totally different kinds of glue polymers. This would give your concrete surface a uniform and constant look. Skim coats might be stained. They also can have stamping achieved to them and decorative saw cuts. Skim coatings are considered an overlay.

Stamped concrete would be considered an overlay too. These start off as a ¼ in. to ½ in. thickness. More prep work is required on the concrete earlier than the stamped overlay is done. The thickness of this would allow the stamping to take place. This might look like a brick road or large chunks of pure stones related together. These will be stained any shade and often need to have a topcoat sealer.

Acid staining gives the concrete a deep and pure look. The concrete must totally be cleaned of any glue, paint, grease, dirt and left over thin set. One of the simplest ways to correctly put together the concrete for this is to cut the ground surface with diamonds to a flat -hundred grit surface. This will insure the concrete is open and the acid will penetrate the surface. Since acid etches and burns the concrete, it is going to be subsequent to impossible to further polish out the concrete. The acid must be neutralized and a topcoat sealer would be applied. These are normally water-primarily based acrylic, solvent-primarily based acrylic, water- based mostly acrylic urethane and solvent acrylic urethane. The acrylics by themselves are inclined to final years and acrylic urethane tend to last 5-7 years. All 4 sealers mentioned are breathable, which is Vidal for keeping you concrete in glorious condition.

Concrete staining is the easiest to do. Its particularly good for model-new concrete. The prep work would contain mainly pressure washing at 2500 PSI and more than a hundred and eighty degrees of scorching water. Hot water expands the concrete and allows the dust to depart so you'll be able to stain it. Cold water cracks the concrete. The proper technician can stain concrete floors the concrete any color.

Concrete polishing is chopping the surface of the concrete until its completely flat. Polish begins off at four hundred grit surface. They will go up to 3000 grit. four hundred grits are usually for stores and may have very little maintenance. three,000 grit can be for high finish homes.

Donate

Contact Address

Shivshakti CHS, A-Wing, 1st Floor, Next to Sahakari Bhandar, S.K. Bole Road, Agar Bazar, Prabhadevi, Mumbai:400025
Tel: +91-22-24311614, 24311616.
FAX : +91-22-2431631,
MOB: +91-9870540453
Mail : This email address is being protected from spambots. You need JavaScript enabled to view it.

NGO | Foundation | Faith Health | Teen Care | Charitable Trust | Children Healthcare | Healthcare Senior Citizen | Teenagers | Seminars for Health Care.